I traced around the base of the box with pencil onto paper. Then i measured in 8mm so it wasnt showing when i stuck the felt on. And then i cut the paper stencil out and cut the felt out. And then glued it on with timber glue.
Thanks. I was going to over time fill in the blanks. Cos i sorta just made it to give to my girlfriend. So i have to backtrack and put the steps in. I dont own power tools. So its all done by rasps, screw driver, sand paper (lots and lots of sand paper) and a half blunt haxsaw saw.
nice work! mind including a little text for guidence? your pictures are clear, but it would be nice to have an additional explanation of how you made this.
2 Comments
9 years ago
Thanks. I was going to over time fill in the blanks. Cos i sorta just made it to give to my girlfriend. So i have to backtrack and put the steps in. I dont own power tools. So its all done by rasps, screw driver, sand paper (lots and lots of sand paper) and a half blunt haxsaw saw.
9 years ago on Introduction
nice work! mind including a little text for guidence? your pictures are clear, but it would be nice to have an additional explanation of how you made this.
Keep it up!