KNEX CAR
Intro: KNEX CAR
this is a car/rover i dont know what to call it if u have any suggestions,coments,or questions coment on the coment board or personal message me
STEP 1: Parts
2 red rods
2 yellow rods
4 red connecters (they r right angle shape)
4 thin circle spacers
1 small wheel
7 large wheels
2 six-spoked wheels ( if u dont have these substitute them with 2 small wheels i did mine with the spoked wheels )
10 big gray spacers
STEP 2: Making the Front
put a yellow rod in 1 end of the red connecter(CONN) and put a red rod in the other end of the red CONN ( U DONT USE THE MIDDLE OF THE RED CONN) . (The red rod will be the front) First slide on a gray spacer on the red rod . Then comes the spoked wheel (you can sub this with a small wheel) After the wheel 4 more gray spacers.Now put on a small wheel. Then 4 more gray spacers. Then the spoked wheel (you can sub this with a small wheel) Then 1 last gray spacer To close the end put a red CONN at the end.
STEP 3: Sides
on the end of both red CONNs in the front put yellow rods, one should have had a yellow piece on it already from before.
STEP 4: The Last Step the Back
red CONN on 1 yellow rod put on 2 blue spacers ,7 big wheels , 2 blue spacers thenput a red CONN on the end and connect the CONN and yellow rod U R DONE
6 Comments
JaredL16 7 years ago
I hate to look like a hater, but... this is *not very good*.I would say go build Masterdude's MMP-1 and learn how to make some decent guns.
NatNoBrains 13 years ago
I flattened myself with it and broke my arm!
Soksume 14 years ago
and see that you should improve your uhh.... vehicle not trying to be mean just saying been there done that a decade ago
Soksume 14 years ago
Mr. Muggle 14 years ago
~KGB~ 14 years ago