Step 1: Gather Materials

For this project, you will need:

x20 White Rod

x4 Blue Rod

x10 Half Circle (Yellow)

x4 Blue 7/8 Circle

x27 Black (or green) Small Rod

x4 Y-Clips (Look like hands)

x7 Grey Connectors

x4 Red Corners

x2 Green Connectors

x2 Full Circles

x6 Orange Connectors

x1 Rubber Band

Step 2: Build the Frame

Start by building what is seen in the picture above

Step 3: Create the Following Parts and Attach As Shown (In Order)

Step 4: Loading and Firing

To load and fire, hold the orange firing pin (located on back left of gun) so that the black pins are upright. Take a rubber band and loop it on the front piece sticking out (black y-piece "hand"). Put it on the three pins in the back, and when ready, release your thumb. The gun should fire, and the rubber band goes quite far. The blue piece sticking out of the back of the gun can be used as a firing pin/stopper. Please be safe, and do not aim at other people. I am not responsible for any injuries caused. Congrats! You're finished!

(Many K'Nex guns are very similar to mine, and I owe credit to many others users, search K'Nex Gun to find more like mine)