K'nex Ball Machine Legacy Update

Intro: K'nex Ball Machine Legacy Update

Hi everyone! This what I have done on my second K'nex ball machine, which is called Legacy. Unfortunately, I was unable to fully finish it in time for the contest. So, I decided to make this to show you guys what I've done so far. Legacy currently has four functioning paths, three lifts, and one new element, the Cross-V Funnel. (It's in the sixth picture.) The video shows two of the paths, both which connect to the Cross-V Funnel. The video also showcases what the machine looks like and some of it's current bugs. If you like Legacy so far, why not vote for it in the Toy Rods And Connectors contest? I would greatly appreciate it if you did. Check back soon to see the finished version of Legacy! See you all next time.

-Knex2thelimit

Comments

[Knexmaster888]

Nice job, looks better than mine, if not, check out discombobulating, also, I voted for you

[Sorunome]

Looking quite sweat! :D

[Knex2thelimit]

Thanks! Also, it's supposed to be spelled "sweet." You just spelled "sweat". :D (It's no big deal.)

[Sorunome]

Seems like i spelled it wrong all the time then :P

[Knex2thelimit]

Lol. :p Don't forget to vote for Legacy in the contest!

[sandroknexmaster]

Looks good so far!

[Knex2thelimit]

Thank you! Don't forget to vote if it gets accepted in the contest. :)

[sandroknexmaster]

I will :)

[sathothy]

Looks very good! Too bad you couldn't finish it in time.

[Knex2thelimit]

Thanks! Yeah, I was disappointed about that too.