Introduction: Knex Ball/Frisbee
More by the author:
About:
(\_/)
(o.o)
(><)
This is a convertable knex ball or frisbee I made.
Step 1: Parts List
Completely unnecessary, but oh well.
Rods:
Gray rod size, flexi: 8
White rod: 1
Connectors:
White:2
Dark Grey:2
Other:
Blue spacer: 1
Step 2: Putting It Together
Again, not necessary, but if you're mentally retarded...
Step 3: Finished!
Now throw it at something.
13 Comments
9 years ago
Nice
13 years ago on Introduction
Wow. I made the same thing like 8 years ago.
If i was on the site then, it wasn't worth posting.
STILL ISNT NOW!
Seriously...
Good work on the ible, but bad project.
Reply 11 years ago on Introduction
OHHHHHHHHHh. You are so mean! C'mon, who wouldn't spend 5 minutes building K'Nex so that they can save like $20?
Reply 11 years ago on Introduction
That makes no sense...? Where does saving come into this? I'm not mean, just fed up of all the sh** that keeps getting posted. About 2 years ago people only posted decent guns worth building, now it's block trigger, block trigger, useless model, etc.
Reply 11 years ago on Introduction
Oh please. Grow up.
Reply 13 years ago on Introduction
Be Nice.
Reply 13 years ago on Introduction
I wasn't really trying to be nasty...
I see your point, though...
(Well I did say good work on the ible!)
Reply 13 years ago on Introduction
I made this when I was about six too.
13 years ago on Introduction
nice!
13 years ago on Introduction
Wow, I made this back when I was six...
13 years ago on Introduction
awesome, works, and simple
very rare 5*
13 years ago on Introduction
This thing is fun! 5*s!
13 years ago on Introduction
havent seen much knex on this site lately 4.5