Knex Confusion

Introduction: Knex Confusion

About: Hi i am a knexer that builds and post how to build guns and weapons. My specilty is guns and new amos.You can subsribe to what ever you feel is cool to you.Remeber to rate,subsribe and comment.All bad comments…

This is the knex ball machine confusion it has 5 paths and 2 working lift with 1 motor and it is connected by gears and chains to make both lifts work at the same time. This ball machine has not been fully finished becuase the motor died on me and I don't have another one so I didn't finish one path becuase of the motor

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    14 Discussions

    0
    airmanT-28
    airmanT-28

    6 years ago

    I wish there were instructions, even if it's not completely finished. I could probably figure it out on my own.

    Hey now! I named my custom TR8 CoNfUsIoN. You stole it! No, I'm just kidding, yours might have been posted before mine, but I did post a turret rifle I named CoNfUsIoN. Although, you didn't alternate caps, but still. :3 It reminds me of it for obvious reasons.

    This is a really nice, compact ball machine. Good job!

    0
    ryry2011
    ryry2011

    Reply 7 years ago on Introduction

    thx I have been hearing this about you on instructables.

    0
    ryry2011
    ryry2011

    Reply 7 years ago on Introduction

    i was going to make a video but the motor died

    0
    ryry2011
    ryry2011

    Reply 7 years ago on Introduction

    thge motor die and i did not have a another motor to replace it. so thats why there is no video. and the description i just forgot but it is there now.

    0
    ryry2011
    ryry2011

    Reply 7 years ago on Introduction

    i know then i was thinking about hocking it up to my dads drill but when we were redoing are kicthen one of the gears got striped.

    0
    ryry2011
    ryry2011

    Reply 7 years ago on Introduction

    i know then i was thinking about hocking it up to my dads drill but when we were redoing are kicthen one of the gears got striped.