K'nex Differential (Version 2)
Intro: K'nex Differential (Version 2)
Car differencial built from k'nex for k'nex vehicle by Forsterimages. Here is what your finnished diff. will look like. Also see version one.
STEP 1: Parts Required
Here is a list of the parts you will need:
2 white connecters,
2 brown cog wheels,
2 grey cog wheels,
4 orange connecters,
4 yellow rods,
4 white rods,
8 silver spacers,
21 blue spacers,
12 black connecters,
1 yellow cog wheel,
some blue tack.
2 white connecters,
2 brown cog wheels,
2 grey cog wheels,
4 orange connecters,
4 yellow rods,
4 white rods,
8 silver spacers,
21 blue spacers,
12 black connecters,
1 yellow cog wheel,
some blue tack.
STEP 2: Step One
Take the white connecters and attach four black connecters.
STEP 3: Step Two
Take two of the yellow rods and attach a grey cog wheel and a blue spacer to each.
STEP 4: Step Three
Take the navy rod rod and attach the two brown cog wheels to each end placing a grey spacer between them. Then place a blue spacer on each end and then some blue tack.
STEP 5:
Take two of the orange connecters and and attach them to both ends of the part made in step three.
STEP 6: Step Five
Take the parts made in steps one and two and place the yellow rod through the middle of the white connecter. Do this twice.
STEP 7: Step Six
Take two red connecters and four black coonecters and attach them as shown. Do this twice.
STEP 8: Step Seven
Take the part made in step four, four white rods and eight blue spacers, and attach them as shown.
STEP 9: Step Eight
Take the parts made in steps five and six and a yellow rod and attach them as shown.
STEP 10: Step Nine
Take the parts made in steps eight and seven and attach them as shown. Leave one grey and one blue spacer for the next step.
STEP 11: Step Ten
Take the part made in step nine and place the yellow cog wheel over one of the yellow rods. Attach it to the nearest white connecter using a piece of wire.
14 Comments
ahmetasc1 9 years ago
i made it but one wheel is always strongest other one.
GWorks 9 years ago
Here's my version:
https://www.instructables.com/id/Smallest-KNEX-Diff...
dommy 13 years ago
David97 12 years ago
adam8949 13 years ago
Speed8ump 14 years ago
MarijnS95 14 years ago
Forsterimages 14 years ago
JonnyDude2008 14 years ago
Forsterimages 14 years ago
wehe-tehe 14 years ago
neilhorse 14 years ago
MarijnS95 14 years ago
arrow shot 14 years ago