Introduction: K'nex Display Stand
Hello fellow humans.Here is the part list to this amazing instructable!!!
Rods:
Green:64
Blue:4
Yellow:3
Red:2
Connectors
Red (3):4
Yellow (5):6
Grey (3D):8
Orange (1):33
Other:
Y (Connector):9
Step 1: Base
1.Build as shown.
2.Add 3 Y connectors on each side (6)
Step 2: Body
1.Build as shown.
2.Build as shown.
3.Gather 2 blue rods.
4.Connected as shown.
5.Connected as shown.
6.Connected as shown.
Step 3: Layer
1.Get 3 yellow rods and put 3 Y connectors at the end.
2.Make a so. (x11)
Step 4: Putting All Together
1.Put all yellow rods threw all orange connecters to make the layer.
2.Gather the base & body.
3.Put together base & body as so.
4.Connected the layer with the base & body.
5.Add three Y connectors at the back.
Step 5: Finished
Congratulations you have made your own K'nex Display Stand!!! Well Done.