Introduction: Knex Forklift With Back-Wheel Steering
More by the author:
About: I've been making stuff with K'nex since I was really young. If you have anything you'd like me to make, let me know and I'll try to make it and then make instructions!
This is the second forklift I have made, the first one could hardly lift anything, this one can lift a lot more, and has steering, so I hope you like it!
Step 1: Making the Lift
This is where you make the lift (or chain) for the forklift.
Step 2: Making the Front Wheels and Steering Wheel
This is where you will make the front half of the forklift.
Step 3: Making the Steering Mechanism and Back Wheels
This might be a little harder, but just look at the pictures and do you best!
Step 4: Making the "Fork"
This is the last part, hang in there, you're almost done!
Step 5: Putting It All Together
This is the end, you made it. Yaaaaaaaaaaaaaaay!!!!!!!!!!!
4 Comments
13 years ago on Introduction
You've got the fork-lift about right there, esp. the rear-wheel steering. No they aren't pretty.
L
13 years ago on Introduction
nice mechanism but it's a bit ugly
13 years ago on Introduction
nice!
13 years ago on Introduction
I lite the mech and that you use the grey pieces chain instead of rope.
But its a bit skeleton... ish