Introduction: Knex Franchi Spaz 12
This gun was made by BlackShadow12, all credit goes to him for the design.
Step 1: Non Working Pump
Step 2: Barrel and Body
Step 3: Stock and Stock Attachment
Step 4: Magazine, Handle, and Mag Pusher
Step 5: Trigger and Ram Rod
Step 6: Non Functional Flash Light
Step 7: Assembly
Step 8: Credit to Black Shadow 12
16 Comments
6 years ago
your gun itself is good though
6 years ago
you do know that you could have used a green conector insted of the broken yellow connector
10 years ago on Introduction
record for most broken pieces in a knex gun?
Reply 9 years ago on Introduction
Lol not all of them are needed. But proabably yah ;)
10 years ago on Introduction
You guys do realize that the SPAS-12 can be, and is gas operated? You don't need to ruin the gun to add a pump.
10 years ago on Introduction
Does the pump work though?
Reply 10 years ago on Introduction
no but i can imagine it could be modded to do so,
Reply 10 years ago on Introduction
ok ill try it
10 years ago on Introduction
this is a beast
10 years ago on Introduction
all the broken rods can be replaced with either yellow or blue rods
10 years ago on Introduction
that is Very VERY VVVVVVVEEEEEEEEEERRRRRRRRYYYYYYYYYYY NICE ME WANT
10 years ago on Introduction
It's pretty good. I think it has some edges that need to be cleaned up, and some editing that needs to be done, but other than that, good job.
10 years ago on Introduction
Cool Gun! I think I'll build it just because I think I can dodge the broken pieces, except that pump will be a bit difficult.
10 years ago on Introduction
Sweet gun!
10 years ago on Introduction
Nice!
10 years ago on Introduction
Thanks for the credit and good job!