Knex Sling!!!!!

Introduction: Knex Sling!!!!!

This is my first instructable that I have published. It is a gun I made yesterday. It's very powerful and it punctures paper!!

Step 1: Pieces You Need.

Pieces you need.

Step 2: Puting It Together.

Put the orange connecter on to the end of the grey rod.

Step 3: Puting It Together.

Put the elastic band through the hole.

Step 4: Puting It Together.

Tie an knot.

Step 5: The Final Bit.

Pull the elastic band back and let go and don't shoot anyone!!

1 Person Made This Project!

Recommendations

  • Candy Speed Challenge

    Candy Speed Challenge
  • The 1000th Contest

    The 1000th Contest
  • Battery Powered Contest

    Battery Powered Contest

67 Discussions

0
Blood Wolf
Blood Wolf

11 years ago on Step 5

Yeah man it reaaaalllly sucks

0
knexinventor72
knexinventor72

Reply 2 years ago

make it before you say it sucks, blood wolf

0
hpayne
hpayne

9 years ago on Step 5

What is it supposed to do

0
knexinventor72
knexinventor72

Reply 2 years ago

it is supposed to shoot, and it does that very well

0
lowe
lowe

Reply 11 years ago on Introduction

unless you break them

0
nebih
nebih

Reply 9 years ago on Step 5

how could the ones you use in this ible break them?? hmm???????

0
rawknexstuff
rawknexstuff

10 years ago on Step 4

It's not that hard to tie a knot. What are you, a preschooler?

0
noobererer
noobererer

11 years ago on Step 5

not bad if u add a red connector to the back with a white rod on it...then u have somewhere to attach the sling (grey connector) to and just push it to fire

0
talons95
talons95

11 years ago on Step 4

that is the best thing ever it is small but mighity not to mention how far it goes

0
imshanedulong
imshanedulong

Reply 11 years ago on Introduction

It doesn't suck! It may be simple, but the best pleasures in life are the simple ones!

0
lowe
lowe

11 years ago on Step 5

not bad 2 *

0
awsome
awsome

12 years ago on Introduction

There you go! Changing the name from "Knex gun" To " Knex Sling" was a wise choice my friend

0
instructable doggie
instructable doggie

Reply 12 years ago on Introduction

hold the gray rod then pull back the single connector on the rubber band then let go of the connector.