K'nex Headphone Stand
Intro: K'nex Headphone Stand
This is what your headphone stand will look like when you are done.
STEP 1: K'nex Headphone Stand
This is the base of the headphone stand and this piece has 4 red connectors, 6 yellow connectors, 2 white connectors and 6 purple connectors. For rods there are 9 white rods and 24 green rods.
STEP 2: This Is the Neck of the Stand
The neck of the stand has 4 blue connectors and 8 purple connectors. For rods there are 7 green rods, 2 red rods and 4 white rods.
STEP 3: Top of the Stand
The top of the stand only has 4 purple connectors. For rods there are 4 white rods and 3 green rods.
STEP 4: Wire Hanger
If you don't have wired headphones then you can skip this step. This has 1 red connector and 1 yellow connector. For rods there is 1 green rod.
STEP 5: Base and Neck Connection
STEP 6: Base and Neck Connected
STEP 7: Top and Neck Connection
STEP 8: Wireless Hanger Done
If you have wireless headphones then you are done!! If you have wired headphones then you have one more step.
STEP 9: Wire Hanger and Neck Connection
STEP 10: Wire Hanger and Neck Connected
STEP 11: YOU ARE DONE!!!
Now you just need to wrap up your cord and put it on the cord hanger. Congratulations!!
STEP 12: Whats Next?
What should i make next out of k'nex write it in the comment section.
3 Comments
jonathan_01 7 years ago
Comment what I should make out of k'nex next!
tomatoskins 7 years ago
Cool Headphone stand!
jonathan_01 7 years ago
Thanks, it really cleans my setup