Introduction: Knex Lever Action Rifle
This gun concept was made by bakenbitz and modded by me.
Step 1: Trigger, Ram Rod, and Mag Rod
Step 2: Stock
Step 3: Lever Mech
Step 4: Barrel and Assembly
broken white can be replaced with a blue connector
Step 5: Special Note
most cut rods can be replaced with blues or white but in the barrell they must stay cut.
7 Comments
10 years ago on Introduction
Did that a long time ago, didnt post it though. I had it set up so it would pull back the pin and load a round. Im glade that someone finally posted it though =D
10 years ago on Introduction
O sh*t-you made his work
10 years ago on Introduction
Nice!
10 years ago on Introduction
I built this a very long time ago. Did you ever figure out a way to make the bullet stay in the barrel after it was loaded? Because mine would always slide out.
Reply 10 years ago on Introduction
I just added some tap to increase the friction
Reply 10 years ago on Introduction
Sorry tape
Reply 10 years ago on Introduction
I guess you can make the top of the barrel, above the lever ramp, a bit looser. So that it acts as a bullet lock,