Introduction: Knex Mag Fed Shotgun 2
More by the author:
About: I paint, write music, and used to build knex guns. I have a Bachelor's Degree in Studio Art. - updated 5/7/2014
Fires 3 gray connectors at a time from 3 magazines.
Uses no broken parts.
VIDEO
1-3: MFS2
4: kNeXFreeK's MFS
5-7: My original drawings.
Step 1: Handle
1: Build three of these.
2: Build this.
3: Gather these.
4: Attach as shown.
Step 2: Shell
1: Build two of these.
Step 3: Magazines
1: Build six of these.
2: Build four of these.
3: Gather two of these.
4: Assemble.
5: Add elastics as shown.
Step 4: Mags Pusher
1, 2: Build this.
Step 5: Barrel Ceiling
1: Build this.
Step 6: Back Section of the Barrel
1: Build this.
Step 7: Barrel Floor
1, 2: Build this.
Step 8: Trigger
1, 2: Build this.
Step 9: Firing Rod
1: Build this.
2: Add duct tape as shown.
Step 10: Assembly
Put everything together. You will still need to add additional pieces in this step. Observe the pictures carefully to find them. Attach elastics as shown.
Be the First to Share
Recommendations
For the Home Contest
Game Design: Student Design Challenge
Make It Bridge
46 Comments
Question 1 year ago
whats the software you made this on?
Question 3 years ago on Step 3
Gebruik extra korte elastiekjes
😃
6 years ago
how did u get the pictures in that way
7 years ago on Introduction
How do u load the magazine quickly when I put in ammo it turns to weird angles making it hard to load.
Great gun BTW.
10 years ago on Step 10
awsome lol first comment
Reply 10 years ago on Introduction
what?
Reply 10 years ago on Introduction
i made the first comment on that step
11 years ago on Introduction
What is the difference between the black rods and the grayish rod, are the black rods heavier or something
Reply 10 years ago on Introduction
allow me to add more info. the grey rods are just plain plastic, which is quite easily bendable and breakable even. the black rods are a stronger type of plastic reinforced with internal fibers, causing for a much stronger piece. they are often used for rams in knex guns because they don't bend or break. they're more reliable than the normal grey rods.
Reply 11 years ago on Introduction
They are sturdier and much harder to bend and break.
10 years ago on Step 7
what is that black thing in the 2 pic
Reply 10 years ago on Step 7
A Y-connector.
Reply 10 years ago on Step 7
ok thanks
11 years ago on Introduction
what program did you use for the pictures?
12 years ago on Step 2
are there supposed to be 2 green rods on the bottom row?
12 years ago on Introduction
HELP! I did everything right but when I put the black rod thing in it wont go in PLEASE REPLY
Reply 12 years ago on Introduction
You have attach the yellow connector that pulls it after you insert it if you didn't build it into the gun during assembly.
Reply 12 years ago on Introduction
Thanks
12 years ago on Introduction
do the bullets get caught inside the barrel and you have to take off the whole top to get it out like the last mgs?
Reply 12 years ago on Introduction
No.