Introduction: Knex Nintendo Wii Stand
Hello, and welcome to my Instructable! Today you will learn howto make a long lasting, quality Nintendo Wii stand out of Knex. It's not hard and uses few pieces. Have fun, and let's get started.
Step 1: Piece Count
Here is the piece count for the stand.
Connectors-
Red - 4
Yellow - 22
White/Black - 30
Grey/Purple - 28
Rods-
White - 55
Green/Black - 116
You have all the pieces, so go!
Connectors-
Red - 4
Yellow - 22
White/Black - 30
Grey/Purple - 28
Rods-
White - 55
Green/Black - 116
You have all the pieces, so go!
Step 2: Sides
Side pieces.
1. Make two of these.
2. Both complete.
1. Make two of these.
2. Both complete.
Step 3: Base
Base. Everything needs one!
1. Make this.
2. Flipped around view.
1. Make this.
2. Flipped around view.
Step 4: Connections
Do I really need to give directions?
1. Both side pieces and base.
2. One side piece connected.
3. Both side pieces connected.
1. Both side pieces and base.
2. One side piece connected.
3. Both side pieces connected.
Step 5: Finish
There. You're done. Congratulations. That wasn't to bad, wasn't it?
Please comment with any mistakes that I may have made or criticism : ).
/
; ) - Supitsgreg
Please comment with any mistakes that I may have made or criticism : ).
/
; ) - Supitsgreg