Introduction: Knex Raiser Lift

By My Youtube Page
About: I'm into knex ball machine stuff. My favourite parts are lift/element hybrids, probably because I tried building a perpetual ball machine. It didn't work, of course. All my knex stuff is creative common, and …
This is the Knex Raiser lift not to be confused with the knex razor lift (Not that there is such thing).

Video: http://www.youtube.com/watch?v=I-WB3c2Y4RA

Step 1: Base

Here's the base.

Step 2: Really Easy Step

Make this!!

Step 3: Ball Holder

This part holds the ball.

Step 4: Putting on the Ball Holder

Just slide it on!

Step 5: Exit Track Bit 1

This part pushes the ball off.

Step 6: Adding Exit Track Bit1

Just put it there!!

Step 7: Next Layer Part1

Make these or make one of them and repeat four times.

Step 8: Next Layer Part2

Now stick them on top.

Step 9: The Crankshaft

This will go in the gap.

Step 10: Adding the Crankshaft

Here's where to put it.

Step 11: Really Really Easy Step

Easier than step 2 :-)

Put this 'extended rod' on the crankshaft and ball holder.

Step 12: Adding in the Motor

Put the motor on the Yellow rod like so:

Step 13: The Top

This part is somewhere between "for show" and "adjusting the pieces"

Step 14: Putting on the Top

On top, where else?

Step 15: Enterence Track

This part is closer to the bottom

Step 16: Putting on the Enterence Track

Near the front

Step 17: Finishing the Enterence Track

Three small pieces

Step 18: Putting It All Together and Finished!