Introduction: Knex Shell Ejecting G36C
This is my new creation it is a shell ejecting knex G36C that i got bored and made and the mecanisim it uses is the same one on my shell ejecting sniper that i made. I hope you like it please rate comment and subscribe!!
28 Comments
6 years ago on Introduction
It is incredible please post!
9 years ago on Introduction
Nice dunkis shell ejecting gun mech. You really improved on his handle
10 years ago on Introduction
On the whole, good job, however it could look more like a G36C.
Reply 10 years ago on Introduction
yea it just has some added support it needed but i didnt have to have it
Reply 10 years ago on Introduction
Come again?
Reply 10 years ago on Introduction
i added some support on the stock that i shouldnt have
Reply 10 years ago on Introduction
Actually the handle and the magazine are the most off
Reply 10 years ago on Introduction
i cant make the mag curved and be shell ejecting and the handle doesnt matter
Reply 10 years ago on Introduction
You can make a half - fake curved magazine, and if you want the replica to be accurate the handle needs to look more like this
Reply 10 years ago on Introduction
whatever
Reply 10 years ago on Introduction
Someones in a bad mood XD
Reply 10 years ago on Introduction
no its just not everything has to be exact
Reply 10 years ago on Introduction
If you call it a G36C, then at least have the courtesy to spend some time perfecting it.
Reply 10 years ago on Introduction
it looks fine the handle is a little diffrent ohwell
10 years ago on Introduction
ok i will have it up soon should i put the clip to or just the barrel part
10 years ago on Introduction
neat
Reply 10 years ago on Introduction
yes it is
Reply 10 years ago on Introduction
ikr
10 years ago on Introduction
Doesn't look too much like the G36c, and you pretty much got that mech from the dunkis anyways.
Reply 10 years ago on Introduction
not the shell ejecting mec i didnt i came up with it