Knex Shuriken
Intro: Knex Shuriken
This is a design that my bro came up with, and i think its actually quite good. it explodes when it lands.
Oh, and this is my first instructable, so please have mercy!! :)
sorry bout the picture quality of some of the photos
Oh, and this is my first instructable, so please have mercy!! :)
sorry bout the picture quality of some of the photos
STEP 1: Step 1-the Pieces
these are the pieces that you will need.
in case the picture doesent load, you will need:
1 snowflake connector
4 orange/brown connectors
8 end connectors (the grey ones)
the 2 "times fours" is a typo. ignore one of them
in case the picture doesent load, you will need:
1 snowflake connector
4 orange/brown connectors
8 end connectors (the grey ones)
the 2 "times fours" is a typo. ignore one of them
STEP 2: Step Two-the End Bits
get the four orange/brown connectors and four of the end connectors and just sorta slot them together like in the picture.
First pic is one piece from two different angles
First pic is one piece from two different angles
STEP 3: Step Three-the Middle Bit
get the snowflake connector and slot grey end connectors at all of the 90 degree slots
STEP 4: Step Four-putting It Together
now take the four pieces you made earlier and slot them onto the remaining bits on the snowflake connector and your done!!!
STEP 5: Step Five-how to Hold
place your thumb and forefinger on either side of the snowflake connector and kinda wrap the rest of your fingers around one of the bits that stick out. You dont have to hold it this way but its my bros creation and he holds it this way. Those are his uber fingers
STEP 6: Step Six-throwing
just throw it any way that you want to.
Enjoy. when it hits its target, it explodes!!! yay!!!
Enjoy. when it hits its target, it explodes!!! yay!!!
8 Comments
darkchalkra1997 10 years ago
Cheezpaper 13 years ago
J4mm3r5 15 years ago
An Villain 14 years ago
J4mm3r5 14 years ago
captain dan 15 years ago
Cerranuss 15 years ago
Cerranuss 15 years ago