Knex Striker Sniper

Introduction: Knex Striker Sniper

About: Formerly was "Legofanatic". It's been a while since I have been on here but I'm thinking about making a come back. Maybe some BMX Instructables and maybe some other stuff hear and there.

This is a Sniper Rifle built off of I am Canadians Striker pistol. I made the handle bigger, I added a stock, and some other little things. Its shot with 4 #64 rubber bands tied together.

Be the First to Share

    Recommendations

    • Holiday Decorations Speed Challenge

      Holiday Decorations Speed Challenge
    • Plywood Challenge

      Plywood Challenge
    • Battery Powered Contest

      Battery Powered Contest

    33 Discussions

    0
    lorzhenk
    lorzhenk

    10 years ago on Introduction

    nice! post it! 5*
    But can i subsitute(orsomethinglikethat) the ball sockets?
    I only got 2 ball sockets...

    0
    GTRPLR1995
    GTRPLR1995

    Reply 10 years ago on Introduction

    Its just there for comfort, Their not really needed. XD

    0
    ~Aeronous~
    ~Aeronous~

    10 years ago on Introduction

    It needs to be stronger, if you held it on its side it would bend. Also the stock is pretty horrible... Not bad though.

    0
    GTRPLR1995
    GTRPLR1995

    Reply 10 years ago on Introduction

    I know, ima build a better sniper one of these days. XD

    0
    H1T4TCH1
    H1T4TCH1

    10 years ago on Introduction

    nice handle, but don't make the trigger so long and don't make the stock that big...

    0
    H1T4TCH1
    H1T4TCH1

    Reply 10 years ago on Introduction

    when that tings are away, it will be a good sniper :-)

    0
    GTRPLR1995
    GTRPLR1995

    Reply 10 years ago on Introduction

    I need to make a better bullet. XD but it is still a nice sniper. Do you suggest anything to do with the stock. I was thinkin bout addin flexy rods for comfort. XD

    0
    H1T4TCH1
    H1T4TCH1

    Reply 10 years ago on Introduction

    no, just keep it simple... don't make the T folds in the stock. just make it pointing one way: downwards. remove the other things above the barrel-rail. you know what i mean??

    0
    GTRPLR1995
    GTRPLR1995

    Reply 10 years ago on Introduction

    Yeah, I posted a pic with it up instead of down but ima change that real quick. XD

    0
    H1T4TCH1
    H1T4TCH1

    Reply 10 years ago on Introduction

    yeah, but i mean that one side (the upper side) have to be kinda 'cutted'.

    0
    DJ Radio
    DJ Radio

    10 years ago on Introduction

    This has been done at least 10 times, just with different bodies and stocks. By far the best ones were by knexguy.

    0
    DJ Radio
    DJ Radio

    Reply 10 years ago on Introduction

    Most were posted in comments and such.