Introduction: Knex Tomahawk
My knex Tomahawk is here and is very good. i thought it will be nice to make a tomahawk for all knex + zombie killing lovers.So get your knex out and start building!
PROS:very good, uses little pieces,great for a zombie killer
CONS,if hit blade on a hard surface blade will break,wobbles.
PROS:very good, uses little pieces,great for a zombie killer
CONS,if hit blade on a hard surface blade will break,wobbles.
Step 1: Parts List
NOTE:LOOK AT THE PICTURES TO SEE PARTS LIST!
Step 2: The Insides,Handle,Stem
pic 1=The inside. (from left to right)= orange connector,blue rod,white connector,tan clip,2 blue spacers,tan clip,White connector,2 blue spacers,orange connector,white rod,orange connector,white rod,white connector,Tan clip
pic 2= add the rods to make handle(cover with 8 rods).
pic 3=Make the stem (cover with 6 rods. leave two across from each other)
pic 2= add the rods to make handle(cover with 8 rods).
pic 3=Make the stem (cover with 6 rods. leave two across from each other)
Step 3: The Blade
pic 1=make the blade
pic 2= save 2 orange flexi rods for later
pic 2= save 2 orange flexi rods for later
Step 4: Assembly
pic 1=connect the blade
pic 2=connect the orange flexi rods.
pic 3= connect the orange fexi to the whit
pic 2=connect the orange flexi rods.
pic 3= connect the orange fexi to the whit
Step 5: Finished
YOU ARE FINISHED HOORAY!!!!!!!!!!!!!!!