Introduction: Knex Br8
This is my tr8 all i did to mod id is slid the rod that holds the turret through the center of the white connectors and put a female ball joint connector on the end of the rod. hope you guys like it also please rate comment and subscribe.

Participated in the
I Made It Photo Contest
48 Comments
12 years ago on Introduction
like how you used red cons for the turret
Reply 12 years ago on Introduction
yeah why?
Reply 12 years ago on Introduction
it looks cooler in my opinion
Reply 12 years ago on Introduction
ooohhhh thx i didnt have enough gray connectors but really i dont have that many knex but i some how make it work
Reply 12 years ago on Introduction
Cool so whats your current project?
Reply 12 years ago on Introduction
maybe a true bolt action rifle any tips?
Reply 12 years ago on Introduction
umm try to include a ram guide and maybe even shell ejecting if you can
Reply 12 years ago on Introduction
k i just want some ideas for the trigger mec and mag area.
Reply 12 years ago on Introduction
ok you could check out my overkill instructions for the trigger
Reply 12 years ago on Introduction
but what about the shell ejecting area and the ram area?
Reply 12 years ago on Introduction
you know im not very good at mags and i never got shell ejecting to work so sorry.
Reply 12 years ago on Introduction
ooh but what about the ram area
Reply 12 years ago on Introduction
um check out this ram
https://www.instructables.com/id/Z35-Knex-Assault-Rifle/step9/Rear-Barrel/
Reply 12 years ago on Introduction
i think i will use the mec on Blue Mullets Bolt action shell ejecting sniper rifle. But thx any way also thx for the trigger.
12 years ago on Introduction
cool stuff man this is my recent TR18 take a look you might like some of the mods
Reply 12 years ago on Introduction
thx
Reply 12 years ago on Introduction
yes sir
12 years ago on Introduction
Thanx, that also has my TR12 turret on there.
12 years ago on Introduction
thx
12 years ago on Introduction
Pretty cool, hey why don't check out this for ideas.