Knex Switch Blade

Introduction: Knex Switch Blade

A switchblade i made while I was bored..

Step 1: Blade/Handle

Follow the steps in the picture.

1. Make 2
2. Make this
4-5. Add these
7. Connect like this

Step 2: Your Done!

If you want just add the rubber band through the red connector so that it flips closed.

Step 3: If You Need Help

If you need help just leave a comment or pm me.

Be the First to Share

    Recommendations

    • Holiday Decorations Speed Challenge

      Holiday Decorations Speed Challenge
    • Plywood Challenge

      Plywood Challenge
    • Battery Powered Contest

      Battery Powered Contest

    2 Discussions

    0
    knexguy
    knexguy

    11 years ago on Introduction

    Not much of an instructable, but a good design nevertheless.