Introduction: Knex Tripod
Basicly, I took my knex music stand, took off the holder, made it taller, and Modded the Hell out of it.
Here it was,
Right here
Enjoy!
Step 1: Follow Instructions
Take off top (of music stand) And then build pic 2.
Step 2: Do This.
get a 1 inch long quarter inch bolt, put through 1 white, clip on blue, add 2 whites, stick yellow rod down middle, add grey clip to yellow, add white connector and 4 greens.
Too many pics.
Step 3: Connect
Done!
18 Comments
10 years ago on Introduction
this is a monopod
Reply 10 years ago on Introduction
I know. I kept the name as tripod because more people are likely to search "tripod" than "monopod", and it does essentially the same thing.
11 years ago on Introduction
would this work with a rb2 mic?
Reply 11 years ago on Introduction
Not as is, but you could easily change it.
Reply 11 years ago on Introduction
I meant, is it sturdy enough to support a rb2 mic, I tried a stand and it failed.
12 years ago on Introduction
If you're not going to tell people how to make the music stand, you could at least include a link to those instructions.
Oh, and you should have made two of these stands.
Then maybe the photos would have been in focus...
Reply 12 years ago on Introduction
and lights!
Reply 12 years ago on Introduction
I used a webcam
Reply 12 years ago on Introduction
right you are!
Why you little!
12 years ago on Introduction
meh... Change it
12 years ago on Introduction
this is not a tripod, it is a monopod, or maybe a quadropod on a flat surface
12 years ago on Introduction
thats a mono-pod, not a tripod.
Reply 12 years ago on Introduction
actually, it is a quadro-pod, but a tripod is in general anything you screw a camera on to.
Reply 12 years ago on Introduction
no, it's not a quadro-pod because the legs are connected. and a tri-pod has to have 3 legs coming out. cameras only use tri-pods because no matter what all three legs will touch the ground.
Reply 12 years ago on Introduction
Whatever im still keeping it as tripod.
Reply 12 years ago on Introduction
it isn't and-pod actually. more of a mount... if it was actually solid.
Reply 12 years ago on Introduction
well, ya, thats mostly what i meant.
12 years ago on Introduction
its a mono pod... and this isn't really even an instructable...