Introduction: Knex Gatling Shotgun V1
This instructable shows how to make my knex gatling shotgun V1 this is the first full auto shotgun in knex history!!! credits: oblitivius cs2 shotgun barrels. ups:low parts usage 8 barrel's 24 shots powerful(usaully gets about 60 feet)more likely to hit target downs:fairly long loading time.parts list:
spacers
blue:2
silver:12
motors
blue motor:1
connectors:
tan clips:2
blue clips:2
yellow conectors:56
red conectors:19
orange connectors:18
grey connectors:8
purple 3-d connector:12
blue 3-d connector:3
white connector:4
rods
grey:11
red:9
yellow:9
blue:16
white:24
green:11
misc
64# rubber bands:16
spacers
blue:2
silver:12
motors
blue motor:1
connectors:
tan clips:2
blue clips:2
yellow conectors:56
red conectors:19
orange connectors:18
grey connectors:8
purple 3-d connector:12
blue 3-d connector:3
white connector:4
rods
grey:11
red:9
yellow:9
blue:16
white:24
green:11
misc
64# rubber bands:16
Step 1: The Wheel
this step shows how to make the wheel.
Step 2: The Axle
This step shows how to make the axle for the wheel to spin on
Step 3: Rams
This step shows how to make the rams
Step 4: Axle
This step shows how to make the Axle and attach it to the wheel.
Step 5: Trigger Flipper
this step shows how to make the trigger flipper.
Step 6: The Base
this step shows how to make the base and connecting the axle to the motor mount
Step 7: Putting the Trigger Flipper On
this step shows how to put the triger flipper on
Step 8: Ammunition
this step shows the ammo
Step 9: Rubber Bands
This step shows the rubberbands you will need
Step 10: Loading ,cocking, and Putting Rubber Bands On
this step shows how to load ,cock,and put the rubber bands on
Step 11: Shooting
cock, load and push the motors switch toward you