Knex Table Top Music Stand.

Intro: Knex Table Top Music Stand.

This is my one PAGE sheet music holder for on a table. it is very simple, and I give credit to
I am canadian.


(because this was part of his v2 mini crossbow, (I start to make it, then relized that there was no way i had enough pieces ( i got very angry)))

STEP 1: Vertical Bit

This is how to build the vertical bit.

you need:

8 purple connectors
3 yellow connectors
2 yellow rods
2 blue rods
8 green rods
1 blue connector
2 white rods.

STEP 2: Music Holding Part

In this step you will receive basic training on how to build the part that has the bottom of the music on it.
There is a blue rod under the red one.
you need:
3 blue rods
6 white rods
2 green rods
2 Grey connectors and
1 red rod

STEP 3: The Making Of

In this step I will teach you the ancient art of assembling the music stand.
You are now ready to proceed to the next level of training,
The super ultra mega knex music stand

you need:
1 green rod

Comments

[Bartboy]

It only works with one sheet at a time, try my other one then.

[Bartboy]

Did you even read that?....

[Katarukito]

it could be used as a target thinking outside comment box

[The Jamalam]

lol, it works too! 5 stars

[Bartboy]

thanks, did you try,

not for trumpet, as when you play loud, it falls over!

[The Jamalam]

not yet, it wont stay up on my bed when i play guitar, so i need to tidy my desk first ;P

[Bartboy]

lol

[I_am_Canadian]

Why Do I get credit?

[Bartboy]

cause all i did was add 3 pieces to part of your bow.

[I_am_Canadian]

Oh.. I see it now. You dont have to give me credit for that...

[Bartboy]

meh