LEGO 1st Gen Ipod Shuffle Dock

Introduction: LEGO 1st Gen Ipod Shuffle Dock

An IPod shuffle dock i made out of LEGO when i was bored and was annoyed with my ipod sitting arround on the desk. My First instructable so go easy. If any one has any ideas on howican improve please let me know.

Step 1: Step 1

Attach the bottom bricks but leave a gap through the centre to fit the cord.

Step 2: Step 2

Put the cord in place and attach the layer of bricks shown.

Step 3: Step 3

Attach another layer as shown

Step 4: Step 4

Now add another layer.

Step 5: Step 5

Now Make this piece

Step 6: Step 6

And attach it to the base like so in the picture.

Step 7: Step 7

Now make two of this piece.

Step 8: Step 8

And attach them like this.

Step 9: Finish

Plug in your ipod shuffle first gen and plug the dock into the computer and your away!!!

Be the First to Share

    Recommendations

    • Photography Challenge

      Photography Challenge
    • Anything Goes Contest 2021

      Anything Goes Contest 2021
    • One Board Contest

      One Board Contest

    Comments