Lakers Skateboard

Introduction: Lakers Skateboard

A skateboard without radians.

Step 1: Skateboard

Use a cuboid to set the length, width and height, and change it into a thin rectangular board.The data of length, width and height are scaled down.

90 centimeters long.

40 cm wide.

2 cm high.

Important are the four wheels that slide and the linkage between the wheel and the board.

After connecting the wheel to the board, the two sections of the board should be slightly tilted up by 5 degrees to ensure smooth flow.

In this way, the appearance of the skateboard was done, and the next step was to make it more beautiful. I added some favorite stickers on the board to make it look better.

1 Person Made This Project!

Recommendations

  • Make it Real Student Design Challenge #3

    Make it Real Student Design Challenge #3
  • Explore Science Challenge

    Explore Science Challenge
  • Arduino Contest

    Arduino Contest

Comments