Hello everyone! This is my first Instructable, a Lego iPhone stand. It uses just a few pieces, but if you're a Lego fan, it will make a great addition to your collection! I have used a vibrant, random selection of bricks to make it easy to see each part, but use whatever colors suit you.

Step 1:

Arrange a 2x4 plate and a 6x12 plate as shown.

Step 2:

Place four 2x3 bricks, two 2x6 bricks, a 2x4 brick, two 1x2 plates, and a 1x4 "lattice" type piece as shown.

Step 3:

Get two 2x2 bricks, two 1x6 bricks, and a 2x6 brick. Place them as shown.

Step 4:

Add two 2x2 bricks and two 2x4 bricks as shown.

Step 5:

Find two 2x3 bricks and two 2x2 slope bricks. Connect them as shown, with the slope bricks facing in.

Step 6:

Place a 1x4 brick, a 2x4 brick, and two 1x2 plates as shown. The 1x2 plates are essential, as they keep your phone from slipping.

Step 7:

Stack three 2x4 bricks and place them on top of the model as shown.

Step 8: Finishing Touches

If you like, you can attach a minifigure to the 2x6 brick that protrudes from the rest of the model. Minifigure's hands are just the right size to hold the charger cord, and add a nice decoration. Thread the charger cord through the hole in the back, plug it in, and you're ready to go!

Step 9: Follow and Check Out My Page for Updates!

https://www.instructables.com/member/PixelMaster1/

Introduction: Lego IPhone Stand