Introduction: Lego Usb
This is a new more compact lego usb
materials:
1 lanyard clip (minus the lanyard)
1 2x3 thick lego brick
1 2x2 thick lego brick
1 2x4 flat lego brick
1 kingmax usb stick (the really compact one)
tools:
exacto knife
drill press
Step 1: Step One
drill 2 small holes in the 2x3 brick as shown in the picture
Step 2:
drill or cut out 2 holes in each of the thick bricks just enough to snugly fit the usb stick inside
Step 3:
loop the lanyard clip as shown in the picture and assemble the pieces together and you have a new lego usb stick
8 Comments
14 years ago
Hey, this is a great instructable and is very informative. Just one thing is missing... pictures! It really helps a lot when trying to follow directions so you should consider taking some photographs. Once you do that and leave me a message when you have so that we can publish your work. Thanks! Thanks for the cool instructable and we hope to publish this soon!
13 years ago on Step 3
After building this same idea I decided to insert some small rare earth magnets in to each of the pieces to hold the cap on rather than use the lower connector. Works perfectly and holds tight. Thanks for the base idea - as always; ideas expand outward.
14 years ago on Step 3
howd u take it off lol?
14 years ago on Introduction
I like this but i have no idea where to get a flash drive that small! Where can you get one?
Reply 14 years ago on Introduction
zatek ebay sells them fairly cheap
14 years ago on Introduction
This is cool thanks!
14 years ago on Introduction
such a great instructable!
14 years ago on Introduction
very informative and simple. Nice Job!