Introduction: Lever Action Rifle
ok so some people have been asking me to post so here it is so if you want to build it then get cracking
!! WARNING USES CUT PARTS !!
video here on how to load and showing it shooting
http://www.youtube.com/watch?v=rSss1Q3T4NQ
also please post your pictures of your versions and ill add them to thhe intro page
Step 1: Main Body
very easy ill add notations if needed
Step 2: Handle and Trigger
same again just follow very easy
Step 3: The Lever Bit
same again
Step 4: Stock
same again just follow pics
Step 5: Banding the Gun
easy just follow
101 Comments
9 years ago
You shod make the lever pull back the fireing pin, I am going to tri it in my Spenser rifle I am going to build
9 years ago on Introduction
Can you technically stop building before the stock?....I think it looks better without it.
Reply 9 years ago on Introduction
yes you could just remove the stock and round the handle into itself would be like a shotgun in length would be pretty cool :)
Reply 9 years ago on Introduction
alright thanks!...i really like this gun.
11 years ago on Introduction
Need a video please send me one of how to shoot it and load it :)
11 years ago on Introduction
Nice gun hopefully I can build it soon.
11 years ago on Introduction
Um... WHY U CLOSE UR YOUTUBE ACCOUNT?????????????
12 years ago on Introduction
I built it, it's AWESOME! However, does every good gun have a part of all those blue rods sticking out? Is there a single good gun that does not have all those rods sticking out? Well, except for the SRV2.
Reply 12 years ago on Introduction
no not at all this gun was mainly based on the main feature with the lever bit but many guns use a system which does make it flat on the outside i have done a couple my self and just so you know i am actually in the procces of improvinng this gun further i think thats just a lucky comment :)
Reply 12 years ago on Introduction
hey, try putting your revolver piece in the place that you load bullets in = lever action revolver
Reply 12 years ago on Introduction
Srv2 has about 120 blue rods sticking out...
Try blue mullets smooth series.
12 years ago on Introduction
just knock out a couple pieces, add an axle and tada!!!!
plz message back
12 years ago on Introduction
please try to build this, what if you replaced the part that comes out of the gun and put a revolving thing? = lever action revolver
12 years ago on Introduction
What does the lever do?Is there a magazine on this?
12 years ago on Introduction
I love it!!!!!!! its amazing; other than the cut parts 5* Heres mine:
12 years ago on Introduction
how does the trigger work?
13 years ago on Introduction
AMAZING!!!! i might build it when i get a few more pieces 5* ;)
13 years ago on Introduction
can you use gray end connectors instead of using the broken pieces?
13 years ago on Introduction
This is madd cool! its not like a repeating rifle its like a sharps where it loads from the back using a lever.
13 years ago on Introduction
I want to make this but i dont have enough parts, do i need a stock and can i make the barrel shorter. i would appreciate it if you replied in a private msg.