Lightweight Ipod in Bed

2,325

1

7

Introduction: Lightweight Ipod in Bed

About: I'm an inactive K'nexer, I used to be one of the most active ones, but I have a lot of other things to do. I try to post a new instructables every few months, but sometimes it takes a while for me to think of …

Based one Jollexs Ipod In Bed, I have made this lightweight one that uses less pieces, and can have either an Ipod classic or Ipod touch without changing anything.

Step 1: Sides

This is the first part oft he sides. Build 2. Thes are the same as in Jollexs .

Step 2: Sides Part 2

Now build 2 of these. They are different and need less pieces.

Step 3: Finish Sides

Connect them and you should have 2 of these.

Step 4: Ipod Holder

Build this, some of the pieces are different, they are just anything that spaces it out, so andything will work.

Step 5: Ipod Stand

Now build this to hold the Ipod holder

Step 6: Complete Ipod Part

Now connect them like this.

Step 7: Finish Up

Now connect it like this and you're ready to go! See intro for how to put the ipod in, and just slide an Ipod touch onto the 4 white rods

The Instructables Book Contest

Participated in the
The Instructables Book Contest

Be the First to Share

    Recommendations

    • Pi Day Speed Challenge

      Pi Day Speed Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Microcontroller Contest

      Microcontroller Contest

    7 Comments

    0
    anaconda
    anaconda

    12 years ago on Introduction

    i made my own and it looks like this. except mine holds the DS and soda........LAZY!!!!! :D

    0
    anaconda
    anaconda

    Reply 12 years ago on Introduction

    i know, i just saw your pics on jollex's one

    0
    The Jamalam
    The Jamalam

    12 years ago on Introduction

    I think you may need to take bigger pictures, but i can make out that it looks quite good tho.