Introduction: Long-range Marshmallow Shooter

      Today, I am going to show you how to make a long-range marshmallow shooter. (And yes, it does shooter far.)

Step 1: Materials

This is what you will need:
1 roll of duct tape
5 feet of pvc pipe
3 "T" connections
3, 90 degree connections
2, 45 degree connections
3, end caps

Step 2: Cutting

You will need to cut 12 pieces:
1, 1 1/2 inch piece
1, 3 inch piece
1, 3/8 inch piece
3, 4 inch pieces
3, 6 inch pieces
2, 7 inch pieces
1, 8 inch piece

The next step will tell you how to assemble it.

Step 3: Assembly

Unlike some shooters, my shooter starts at the back end.

First: take the 1 1/2 inch piece, a cap, and a 45 degree angle connection, and put them together.

Second: Take 2, 7 inch pieces, a 45 degree angle connection, 2, 90 degree connections, and a 4 inch piece, and put them together as shown.

Third: Take 2,4 inch pieces, an 8 inch piece, a 90 degree connection , and a "T" connection, and put them together as shown.

Fourth: Take 2 "T" connections, 2 end caps, 3, 6 inch pieces, and the last two pieces. Put them together as shown.

Step 4: Have Fun!

     Remember: I am not responsible for any marshmallow/pvc related injuries. This is my first instructable. Have fun, but be responsible.

The Mad Science Fair

Participated in the
The Mad Science Fair

Hack It! Challenge

Participated in the
Hack It! Challenge