Make a Duct Tape Wind Surfer

Intro: Make a Duct Tape Wind Surfer

Fly on a skate board on your brand new DUCT TAPE WINDSURFER!

STEP 1: What You Will Need

3 or 4 Rolls of Duct Tape (Ace brand is the best, it is light)

Scissors

NewsPaper

2 Straight Sticks

STEP 2: Duct Taping

1. Lay out 4 sheets of newspaper

2. Duct Tape them together with a "X"

3. Then go and lay strips in a cross on theends of the paper that is overlapping

4. Cover each section with Duct Tape

5. Repeat for the other side

6. Cut off the sticky edges

STEP 3: Support

1. Find two straight sticks and tape them on each side.

STEP 4: Done!

You are done now go surfing! If there is no wind get a fan and skate!

Please reply your photos!

Comments

[phoenix12]

A less time consuming process would be to go to the hardware store and get heat sealed plastic. Lay out plastic over sticks and heat seal the edges. Use hair dryer or heat gun to shrink to desired size.

[KentsOkay]

Really needs a video of it in use :D

[DuctTapeCrazy]

It is the windiest where I live during summer, righ now there isnt much wind. But I try going on a fan.

[rkin5]

it won't work if the fan is attached to the skateboard, newton's laws... newton's laws.