Maker Skateboard

Introduction: Maker Skateboard

On the other side of the Pacific Ocean in the late 1950s,descendants of Edison, who were good at inventing, more or less turned the fantasies of ancient Shenzhou into reality.The West Coast of the United States was a place for trendsetters to try their best in the early 1950 s. They use surfboards made of ordinary wood and expensive light wood to have fun on the tip of the storm. because we are Maker studio,so i added the words Maker.

Step 1: ​Step1:Create Sketches and Stretch Sketches to Form Models.

1.1The plate length is 90mm, the height is 4mm, then has a radian, is a whole.

1.2Build the connection mode of skateboard and wheel, screws, chassis, etc.

Step 2: Step2:Create the Wheel and Connect With the Board.

To draw a sketch and build a wheel, use a mirror to build four wheels.

Step 3: Step3:improve the Appearance and Details to Make the Skateboard More Beautiful.

complete skateboard.

Skateboard Contest

Participated in the
Skateboard Contest

Be the First to Share

    Recommendations

    • Eggs Challenge

      Eggs Challenge
    • Sculpt & Carve Challenge

      Sculpt & Carve Challenge
    • Build a Tool Contest

      Build a Tool Contest

    2 Comments

    0
    Penolopy Bulnick
    Penolopy Bulnick

    2 years ago

    Nice job using Fusion to design this :)

    0
    2466568012
    2466568012

    Reply 2 years ago

    sure I really like it