Introduction: Mini Christmas Tree Made With ATtiny13a and Mini Breadboard.
While the whole street is colored with Christmas, I made a small Christmas tree with ATtiny13a and small breadboard. I found cute little case at the 100 yen shop. the case was a dome ornament kit. I put a small Christmas tree in the case. Do not you think it is is cute?
Make it happy:-)
Step 1: Sketch
Fuse bit :hFuse = 0xFF, lFuse= 0x7A (interne 9.6 MHz clock)
Step 2: Material
1x Mini breadboard
1x 150 ohm resistor
1x 3mm Red LED
11x 3mm Green LED
Step 3: Jumper Wire
Step 4: LED
Please also refer to the video for making.
Step 5: Casing
Power supply uses 5V from USB. Please be careful with polarity.
I put a small Christmas tree in the dome ornament kit I found in the 100 yen shop.
I think that a small bottle is also cute:-)
Step 6: Finish!
have fun :-)