Mini Disks Bracelet

413

5

5

Introduction: Mini Disks Bracelet

Heyo! This is my tutorial on my Mini Disks rainbow loom bracelet. This is my original design, and yes, I finally figured out Pixlr!!!!!!! When you have your supplies, move to Step 1!

Step 1: Placing Bands

Place bands like you would a single, and continue all the way down your loom.

Step 2: Placing "Disk" Bands

These are basically cap bands. Wrap them around your loom 2 times, and continue down the loom. Stop when you have used all your bands.

Step 3: Hooking

Go under your cap/disk band and hook the band. Continue until you have hooked every band.

Step 4: Removal and C-clip

On the last band, take your c/s clip and attach one side to the bands. Remove from the loom gently, and then clip the other side.

Step 5: We're Done

We're done with the bracelet! I hope you enjoyed this tutorial, I accept requests for instructables! Bye!

Be the First to Share

    Recommendations

    • Raspberry Pi Contest

      Raspberry Pi Contest
    • Jewelry Challenge

      Jewelry Challenge
    • Anything Goes Contest 2021

      Anything Goes Contest 2021

    5 Comments

    0
    mazzy-m
    mazzy-m

    7 years ago on Introduction

    Hey loomers! I have a big surprise! I just published an instructable on a triple single for the monster tail loom!