Introduction: Mini XY Laser Engraver by Makeblock

About: Makeblock was founded in 2012 as the world's first open-source robot and programing platform. With more than 400 mechanical components, electronic modules, and software tools, we are determined to bring meanin…

As one of the most practical kits in Makeblock platform, XY Plotter functions as a drawing robot in its initial form and a laser engraver after adding an add-on pack. Makeblock XY Plotter has been highly acclaimed in various exhibitions, such as Maker Faire. However, the size of XY means it's not a portable machine, especially for people who need to present it during every business trip. Hence we designed this mini XY laser engraver for portability.

More tutorials please visit

Our community:


the other relevant article

Step 1: Assemble the Frame

Step 2: Assemble the Linear Motion Slide & Shaft

Step 3: Install the Supporting Leg

Step 4: Assemble the Short Beam0824 (1)

Step 5: Assemble the Short Beam0824 (2)

Step 6: Install the Other Set of Linear Motion Slide & Shaft

Step 7: Fix the Stepper Motor Module

Step 8: Install the U Bracket

Step 9: Assemble the Timing Pulley

Step 10: Assemble the Long Shaft and Timing Belt

Step 11: Fix the Timing Belt

Step 12: Install the Other Stepper Motor Module

Step 13: Install the Fixing Plates

Step 14: Install the Timing Belt

Step 15: Install the Laser Head

Step 16: Install the Micro Switch

Step 17: Install the Orion Main Board and Laser Driver

Step 18: Install the Stepper Motor Driver

Step 19: Wire Up and Install the Footpad

Step 20: Sucess

Circuits Contest 2016

Participated in the
Circuits Contest 2016