Introduction: My K'nex Pistol

By
About: I like video games a lot. Mostly guitar hero and rock band. I love the computer too. I like to go outside though. I'm not fat if that's what you were thinking.
This is the K'nex gun I built in a day or two. I did not copy any designs if that's what you were thinking.
It is not automatic but gives a crapload of power, since it is a slingshot type of gun instead of a ram.

game instruct instructable the the create how to make

Step 1: The Tip

Short white rods: 3
Short green or black rods: 3
Small black connectors/rods: 2
White or yellow 5 slot connectors: 3

Step 2: The Barrel

Short white rods: 4
Short green or black rods: 12
Small black connectors/rods: 8
White or yellow 5 slot connectors: 12

Step 3: Connect E'm Both

You need both pieces you were just working on for this step.

Step 4: The Spoke

White or black 8 connector pieces: 1
Short green or black rods: 8
Gray one connector pieces: 12
Gray spacers: 2
Short blue rods: 1

Step 5: The Body

Short green or black rods: 11
Short white rods: 3
Short blue rods: 2
Small black connectors/rods: 2
White or yellow 5 slot connectors: 10
Green 4 slot connectors: 2

Step 6: The Trigger

Red or gray 3 slot connectors: 1
Short black or green rods: 2
Gray 1slot connectors: 1
White or yellow 5 slot connectors: 1
Short blue rods: 2
You will also need the body.

Step 7: The Handle

White or black 8 slot connectors: 2
Short white rods: 4
White or yellow 5 slot connectors: 5
Short blue rods: 1

Step 8: The Final Assembly

You will need the spoke and the body.

Step 9: The Final Assembly Part 2

You will need the handle and the body.

Step 10: The Rubber Band

You will need the barrel and a rubber band.

Step 11: Final Assembly Part 3

You will need the barrel and the body.

Step 12: The Ammo

Use the red or gray 3 slot connectors for ammo.

Step 13: The Saftey Pin

Put the pin through the hole of the bullet and the hole of the closest white or yellow 5 slot connectors.
Blue rods: 1
Blue one slot connectors: 1
BWT you dont need the safety pin. its just there in case it mis-fires.

Step 14: Loading

Pull the rubber band back until it reaches the spoke. Put it on the same latch as in the picture. Then put the bullet where it is in the picture. It will get the most power in this spot. You can adjust the intensity by getting a different size rubber band or adding more sections to the barrel.