Introduction: NAPKİN HOLDER (MOBİLE CHARGİNG CENTER)
I make this product specially for cafe and restaurants. İt includes a powerbank which has 12000 MA cappacity and two outputs(2,1A and 1A). So you can charge your phone, tablet, laptop etc. during drinking your coffee.
Today charge of our phones is very important.
I wil explain how ı made ıt ın steps wıth photos and videos. You can look and you can make yours.
I wıll share ıts project ın dxf and pdf file format.
Fırst of all ı design ıt on Corel Draw. Than ı cut ın laser cutting machine. I use 2.7mm Mdf. After fınıshed cutting step, ı combine pieces with super fast glue. I show each piece on photos.
Finally ıts ready to use...
Step 1: DESİGN PROCESS
Step 2: LASER CUTTİNG PROCESS
Step 3: COMBİNE PROCESS
Step 4: ITS READY FOR USE
Step 5: DESİGN FİLE (DXF and PDF)
Participated in the
Epilog X Contest
4 years ago
Practical idea. Thanks for sharing with us.
Reply 4 years ago
Thank you so much for your kindness. I wıll contınue to share my designs on İnstructables.