Introduction: NES Controlled Etch-A-Sketch
Drawing on an etch-a-sketch using an original Nintendo controller. I connected the etch-a-sketch knobs to stepper motors, which are then controlled by an Arduino microcontroller. The Arduino program I wrote takes signals from the NES controller and sends them as stepper motor control instructions.
2 Comments
9 years ago on Introduction
vid not showing
Reply 9 years ago on Introduction
Sorry everyone, there seems to be issues with the uploader. I can't edit the instructable either. Here is the video on YouTube:
http://www.youtube.com/watch?v=WCkh4s1q1WQ