Old Jar Sharpener

852

10

3

Introduction: Old Jar Sharpener

About: Heya, I'm Helen and I love to make and learn how to do stuff.

This is my instructable to make a sharpener out of an old jar.

Step 1: What You Need

Here is what you need:

- an old jar

- a sharpener

- a hammer

- nail or screw

- hot glue

Step 2: First the Lit

First you need to mark where your sharpener should be on the lid.

Now use your nail or screw to make holes in between the mark (picture 2) until it turnes into one line. (picture 3)

Step 3: Add the Sharpener

Now put the sharpener into the line and use your hammer to get the sharpener into the lid. It shoud look like picture 3. Be a little careful with the little screws at the sharpener when they touch the lid.

Step 4: Safety First

The edges are sharp after you pounded the sharpener into the lid (picture 1). To prevent yourself from cutting yourself or others you can put some hotglue around the sharp edges (picture 2).

Step 5: Paint It

The lid might get a bit dirty during the hammering but you can just paint it over and give it a final touch, depending on how your room or workspace is decorated.

Step 6: There You Go

There you go an - Old Jar Sharpener -

Be the First to Share

    Recommendations

    • Pi Day Speed Challenge

      Pi Day Speed Challenge
    • Trash to Treasure Contest

      Trash to Treasure Contest
    • Sculpt & Carve Challenge

      Sculpt & Carve Challenge

    3 Comments

    0
    YourMagesty
    YourMagesty

    4 years ago

    I - L O V E - T H I S !!!!! Very cool project, that handles the shavings very nicely!

    0
    YourMagesty
    YourMagesty

    Reply 4 years ago

    (just thinking here..... Perhaps protect the lid while hammering the sharpener? That would eliminate the need for painting)? GREAT PROJECT!

    0
    He Se
    He Se

    Reply 4 years ago

    Thank you :) Yes that would be a good plan!