Operating the Object Connex 500

Introduction: Operating the Object Connex 500

About: Autodesk Technology Center San Francisco is a hub for research, development, and demonstration of new manufacturing technologies and workflows relating to configurable microfactories.

Use this lesson as a reference for order of operations when cutting on the Epilog Laser Cutter.

Step 1: Area and Machine Preparation

  1. Prepare the model.
  2. Select a printer.
  3. Insert (open) the model.
  4. Set tray and material options.
  5. Send the tray to the Job Manager.

Step 2: Printing the Model

  1. Run the Job Manager.
  2. Bring the printer online.
  3. Record the resin usage.
  4. Start the print job.

Step 3: Cleanup

  1. Remove your part from the machine.
  2. Clean the machine.
  3. Clean your part.

Step 4: Print Out This Guide

This course is available as a PDF that is attached to this step. Happy printing!

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    Discussions