PVC Clarinet

18,080

32

6

Introduction: PVC Clarinet

About: an earth human who likes geeky techy stuff

This is something I made a couple of years ago. It's basically a piece of pvc with a standard clarinet mouthpiece glued on. The finger holes were measured to make it in-tune. Takes a lot of air pressure, but it sounds rather nice for a piece of pvc (I'm a very amateur clarinet player so forgive the playing.)


Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • Anything Goes Contest

      Anything Goes Contest

    6 Discussions

    0
    rickharris
    rickharris

    9 years ago on Introduction

    It actually sounds quite good - PLEASE make the instructable showing the sizes so others can DIY as well.

    0
    theaustindixon
    theaustindixon

    Reply 9 years ago on Introduction

    I will when I can. I built this a few years ago, so I don't remember all the measurements. I'll have to go back and see if I can find my notes.

    0
    SteveT130
    SteveT130

    3 years ago

    Really cool. Just happen to have a spare mouthpiece layin' around. Any chance we can get the measurements. If you don't have the notes, how about measuring it out. Thanks.

    0
    Pieislife11
    Pieislife11

    5 years ago

    You should add a funnel at the bottom

    0
    bonnyjishop
    bonnyjishop

    8 years ago on Introduction

    if this inspires you as it did me check out this guy on youtube who made a carrot clarinet Its amazing !!! http://www.youtube.com/watchv=LWbj7FYEi3M&feature=endscreen

    But what is the full title of the mouthpiece please?