Introduction: Parachute Ping-Pong Slingshot Molded in TinkerCAD!
View Tinkercad link here:
https://drive.google.com/drive/folders/1vC7F3vYEAlPcMwutj5sZ-wRRTL0xGW7E?usp=sharing
Step 1: Making the Hole
Make a hole in your ping-pong ball.
Step 2: Cutting Off the Zipper
Cut the zipper off your plastic bag.
Step 3: Taping the Thread
Tape 4 pieces of thread to your plastic bag.
Step 4: Taping the Hole.
Put the thread in the hole we made in step 1 and seal with a piece of duct tape.
Step 5: Gathering and Covering 4 Popsicle Sticks
Make 2 stacks of 2 popsicle sticks, and cover with duct tape.
Step 6: Arranging and Placing
Arrange popsicle sticks in a V shape and place popsicle stick 1 3/4 inch from the bottom.
Step 7: Measuring and Cutting
Draw 2 lines as shown on the image above and cut on the lines.
Step 8: Cutting
Cut on lines and cover with duct tape
Step 9: Putting in Screws
Put 2 screws and bolts in the popsicle sticks.
Step 10: Making the Handle
Gather 6 popsicle sticks and cover with duct tape.
Step 11: Screwing in Place
Screw handle in place.
Step 12: Tying the Rubber Bands
Tie 2 rubber bands to the slingshot as shown.
Step 13: Enjoy!
Enjoy your new slingshot!