Parts & Hardware Organizer

by TabLeft

6.4K1319

Intro: Parts & Hardware Organizer

Simple cheap wall mounted hardware & parts organizer.

The design allows for easy batch assembly, low cost lumber, customization of bin size, and easy future expansion.

The material used could vary, but for the video I used 1x4s(3), 2x4(1) and about a quarter sheet (2'x4') of 5mm underlayment to make 18 4" wide bins which easily hold a full standard size box of screws.

This was made on the cheap with materials I already had on hand, but probably less than $15 total cost for the materials I used if you needed to buy it all.

9 Comments

WoodMagnolia 7 years ago

I have wanted to make these bins for ages, I just didn't want the tedious repetition of making single bins. You have shown me I don't have to make them one bin at a time! Thank you so much!

Snowberry 9 years ago

I can only see the intro. Unfortunate, looks like something i would like to make

seamster 9 years ago

These look excellent!

I made something similar a while back, but without the open areas up front to easily see into the boxes to see the contents, which is a huge drawback. Wish I had made mine more like yours.

Your design looks perfect!

TabLeft 9 years ago

Thanks! They have been super handy, I wish I had made them years ago.

rsarpy 9 years ago

did someone forget to add the instructions?

TabLeft 9 years ago

The video is pretty self explanatory. If you're on mobile for some reason the site just shows a picture of my video instead of the actual video.