Printrbot Rev-D Tight Motherboard Enclosure

By rileyt in Workshop 3D Printing

617

Printrbot Rev-D Tight Motherboard Enclosure

this is a housing for a Printrbot REV-D motherboard used on all printrbot 3d printers. this is specifically for external electrical setups on 1" ALU extrusions and a 20mm fan cooling system.

the files in STL can be found here-<http://www.thingiverse.com/thing:489543>

Be the First to Share

Recommendations

Bearing From Aluminum Beverage Cans by BevCanTech in Metalworking

12 3.1K

Stretchy Elastic Stitched Neck Choker and Bracelets by Penolopy Bulnick in 3D Printing

29 2.1K

3D Printed Monstera Leaf Clutch by kura_kura in 3D Printing

52 3.4K

Circular Table Re-Design (Three to Single Leg) by Timbermancrafts in Woodworking

18 3.5K

Make it Fly Student Design Challenge
Halloween Contest
Project-Based Learning Contest

Comments

seamster

8 years ago on Introduction

Cool, thanks for sharing this.

Introduction: Printrbot Rev-D Tight Motherboard Enclosure

Be the First to Share

Recommendations

Make it Fly Student Design Challenge

Halloween Contest

Project-Based Learning Contest

Comments