Introduction: Project N (Knex Ball Machine) - the Smallest and Most Pointless Ball Machine Ever
More by the author:
About: .
This is the smallest ball machine on instructables. It has no elements it just goes up and comes down. If you guys want I can post instructions.
23 Comments
13 years ago on Introduction
Use a drill to power it!
Reply 12 years ago on Introduction
**Thoughtful Face** Use a Dremel to power it! :D
Reply 11 years ago on Introduction
Use a Hemi Engine like one of those blenders!
11 years ago on Introduction
Mine is smaller
project tiny
Reply 11 years ago on Introduction
i bet it is
12 years ago on Introduction
lol 5* for awesomeness
15 years ago on Introduction
if you ran the motor fast enough, then you could create a ball machine gun! =D
Reply 14 years ago on Introduction
lol. You buy one of the 18 000 rpm motors, then connect it.....
Reply 12 years ago on Introduction
...and blow up the fergin world!
sounds fun though
13 years ago on Introduction
Its actually not the smallest.
13 years ago on Introduction
Nice! ball machine!
14 years ago on Introduction
bart boy made a smaller one.
Reply 14 years ago on Introduction
That was so simple... lol.
14 years ago on Introduction
5*/fav/sub NO KIDDING =D
Reply 14 years ago on Introduction
Thanks.
14 years ago on Introduction
you made that?????????????
Reply 14 years ago on Introduction
Yeah.
14 years ago on Introduction
Its oddly interesting.
15 years ago on Introduction
make like 220 of them, put in a row, and turn the motors on all consequtavley, so they are out of sync!
15 years ago on Introduction
LOLOLOLOLOL This is hilarious, i will build if you post =D