REPAIRING PIMPING UP a 2.4GHZ ANTENA

By in WorkshopRepair

710

2

2

Introduction: REPAIRING PIMPING UP a 2.4GHZ ANTENA

By

REPAIRING PIMPING UP A 2.4GHZ ANTENA

Maid stepped onto the telephone and the only thing salvageable was the anntena. A bit of tape, thermofit and a heat gun was all I needed it, Yeap! I was bored when I thought of this pointless project unless I find another project where to use this anntena, was fun though

Be the First to Share

    Recommendations

    3D Printed Flexi Snake
    3D Printed Flexi Snake by Penolopy Bulnick in 3D Printing
    47 5.4K
    Glow in the Dark Molecules
    Glow in the Dark Molecules by mphatsosimbao in 3D Printing
    7 1.2K
    Mobile Folding Craft Station
    Mobile Folding Craft Station by Yvette M in Woodworking
    118 5.9K
    A Pocket Sundial From a Broken Pocket Watch!
    A Pocket Sundial From a Broken Pocket Watch! by JGJMatt in Metalworking
    80 8.0K

    • For the Home Contest

      For the Home Contest

    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge

    • Big and Small Contest

      Big and Small Contest

    2 Comments

    0
    seamster
    seamster

    8 years ago on Introduction

    Thanks for sharing. That antenna will come in handy sometime!

    0
    macglobalus
    macglobalus

    Reply 8 years ago on Introduction

    You can apply the same technique to any pole antenna regardless wheter you use it to repair o make a new one, cheers!