RFID Module

Introduction: RFID Module

A RFID module reads the UID tag value to open a lock which is operated by a RFID . We just have to place the card in front of the RFID sensor and the RFID opens the door.

For what and whom have we made it?

Robbers mostly break the lock and enter a territory. A solution of preventing this is here.A RFID uses artificial Intelligence to open locks. So, this is a very important discovery in today's world.

Materials required

  • RFID Module
  • Breadboard
  • 2 different coloured led's.
  • Jumper Wires
  • Servo Motor
  • Arduino UNO Micro-computer
  • 2 no. 220 k ohm resistor

Step 1: Make a Proper Circuit

Step 2: Code

Step 3: Some Tips

  • The frequency of RFID Module must be set correctly.
  • The connections of the RFID receiver and Arduino should be made correctly.
  • The UID Card must be synchronized properly.
  • Refer Internet while making as the circuit and code is complicated.

Step 4: Final Session

Be the First to Share

    Recommendations

    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge

    2 Discussions

    0
    da3ge1
    da3ge1

    4 months ago

    You say "Refer Internet while making as the circuit and code is complicated." What's the URL?