RING NUT

By in WorkshopMetalworking

3,316

73

6

Introduction: RING NUT

A RING MADE FROM A NUT.

Step 1: RING NUT

CLAMP IT.

Step 2: RING NUT

DRILL IT.

Step 3: RING NUT

SAND IT.

Step 4: RING NUT

WEAR IT.

Step 5: RING NUT FINISH

FINISHED RING!

Rings Challenge

Participated in the
Rings Challenge

On a Budget Contest

Participated in the
On a Budget Contest

Be the First to Share

    Recommendations

    Build a Cuckoo Clock From Scratch
    Build a Cuckoo Clock From Scratch by Sawdust Willy in Woodworking
    12 947
    Putter Restoration
    Putter Restoration by designcoyxe in Metalworking
    15 2.8K
    Converting Brass Hardware Into Potentiometer Knobs With 3D Printing
    Converting Brass Hardware Into Potentiometer Knobs With 3D Printing by neonstickynotes in 3D Printing
    17 715
    Simple Juice Groove Jig for Cutting Boards
    Simple Juice Groove Jig for Cutting Boards by rschoenm in Woodworking
    10 698

    • Game Design: Student Design Challenge

      Game Design: Student Design Challenge

    • Clocks Contest

      Clocks Contest

    • Baking Contest

      Baking Contest

    6 Comments

    0
    CarlosS107
    CarlosS107

    6 years ago

    What kind of bit?

    0
    carpenterDSA
    carpenterDSA

    Reply 6 years ago

    a step down bit.

    0
    MsSweetSatisfaction
    MsSweetSatisfaction

    7 years ago on Introduction

    This looks great, and I love the simplicity of this build! I bet you get lots of compliments on it when you wear it out!